DJI Goggles 3 are worth it if you fly an Avata 2, Neo, Air 3, Mini 4 Pro or an O4 Air Unit build and want the sharpest, lowest-latency DJI feed: two 1080p micro-OLED screens at up to 100 Hz, latency down to 24 ms with the Avata 2, built-in diopter adjustment and Real View pass-through. If you only fly an Avata 2 or Neo casually and wear glasses, the cheaper Goggles N3 does the job.
DJI Goggles 3 specs
| Spec | DJI Goggles 3 |
|---|---|
| Screens | Two 0.49-inch, 1920×1080 each, up to 100 Hz |
| Field of view | 44° per screen |
| Latency | Down to 24 ms at 1080p/100fps, 40 ms at 1080p/60fps (with Avata 2) |
| Max range | 13 km FCC with Avata 2 |
| Max live view bitrate | 60 Mbps |
| IPD | 56 to 72 mm |
| Diopter | -6.0 D to +2.0 D (-2.0 D add-on lenses included) |
| Weight | About 470 g with battery |
| Battery | 3000 mAh, 21.6 Wh, about 3 hours |
| Storage | microSD up to 512 GB |
All figures are from DJI's spec sheet and user manual. Latency and range are measured in open, interference-free conditions, so expect less in a park full of Wi-Fi.
What you actually get
Image quality. The 44° field of view is narrower than the N3's 54°, which makes the picture look denser and sharper because the same 1080p pixels cover a smaller area. The tradeoff is less peripheral view. Many pilots like the tighter view for cinematic flying; racers who want the widest view may not.
Latency. 24 ms at 1080p/100fps with the Avata 2 is DJI's lowest figure for its consumer goggles. With an O4 Air Unit in racing mode, DJI quotes down to 20 ms. It feels close to instant for freestyle and cinewhoop flying.
Comfort. About 470 g with the battery in the rear of the headband, so the weight is balanced front to back. The forehead pad is built in and the foam is replaceable.
Real View. Two cameras on the front let you see around you without taking the goggles off. Double-tap the right side to switch. With Real View PiP on, the flight feed shows in a corner. See Goggles 3 Real View PiP.
Head tracking. Turn your head to yaw the drone and tilt the camera, with an Avata 2, Neo, Air 3 or Mini 4 Pro and the RC Motion 3. More in Goggles 3 head tracking.
Downsides
- No analog support and no HDMI in or out.
- The battery is built in, so you can't swap it. You can run the goggles from a USB-C power bank instead.
- It only works with DJI digital systems. The Air 3S, Mini 5 Pro, Mavic 4 Pro and Flip don't support any DJI goggles.
- Flying in goggles doesn't count as visual line of sight. Under FAA rules you need a visual observer beside you.
Setup in four steps
- Charge the goggles with a USB-C PD charger.
- Connect them to your phone with the OTG cable and activate them in DJI Fly, online.
- Link the drone and controller, by the Connection Guide in DJI Fly or the link buttons. See binding Goggles 3.
- Set IPD and diopters with the knobs underneath, then lock them. See glasses and diopters.
The full user manual is on DJI's Goggles 3 downloads page.
Goggles 3 or Goggles N3?
Pick Goggles 3 if you want the best feed, wear glasses with a prescription between -8.0 D and +2.0 D, want Real View, or fly an Air 3, Mini 4 Pro or O3/O4 build. Pick Goggles N3 if you fly an Avata 2 or Neo, want a wider view, and prefer to keep your own glasses on. Full breakdown in Goggles 3 vs Goggles N3 and which drones work with DJI goggles.
Ready to upgrade? Shop DJI Goggles 3 or browse the FPV goggles collection.
Related guides
- DJI Goggles 3 and Goggles N3 compatibility: which drones work?
- Can you use DJI Goggles 3 or N3 with a simulator like Liftoff?
- Can you wear glasses with DJI Goggles 3? Diopters and prescription lenses
- DJI Goggles 3 accessories: straps, foam, cases and mounts
- DJI Goggles 3 head tracking: setup and fixes
- DJI Goggles 3 Real View PiP explained
Not sure which to pick?
Tell us what you'll fly and your budget. One of our drone pilots will reply with a recommendation.
Buying drones for a business, agency or store? Get wholesale pricing →
